tubes question

Joined: 13 Feb 2004 Posts: 5603 Location: phoenix az.

K so my question is i want to change the power tubes in my dsl 100 Marshall.theres 4 el 34 power tubes.my question is this.I only use the clean channel on the amp.do i need to change all 4 output tubes or are 2 tubes for one channel and 2 for the other?or does the amp just run all 4 at once to power?

Joined: 07 Aug 2007 Posts: 2740 Location: Southeast MI

It runs all power tubes at once. The preamp tubes are the ones that might be some for the clean, some for the distortion, this one for effects loop, this one phase inverter, etc, but the power tubes are always working.

Joined: 13 Feb 2004 Posts: 5603 Location: phoenix az.

thxs

Joined: 22 Feb 2008 Posts: 820

you also have to change them as a quad matching set and set the bias. there's a whole set up to go threw. cab plugged in to head ect

Posted: Thu Feb 14, 2013 10:31 am

RobBouchardDeanml wrote:

K so my question is i want to change the power tubes in my dsl 100 Marshall.theres 4 el 34 power tubes.my question is this.I only use the clean channel on the amp.do i need to change all 4 output tubes or are 2 tubes for one channel and 2 for the other?or does the amp just run all 4 at once to power?

The way your asking it, I'd answer did it have a half power switch? That's the way only 2 or 4 tubes would be used. But yes change all the tubes.

Joined: 13 Feb 2004 Posts: 5603 Location: phoenix az.

i am and my buddy will bias it for me