Does anyone know the part # for a Tone Pros locking Bridge

Posted: Sat Nov 17, 2012 9:04 pm

... for a USA Dean TCZ? I'm so pissed!!! The bridge is actually cracked at the post... WTF?!

There are so many replacement pasrts and I want a direct replacement. Looks like it may be an T3BP ... but not sure.

Thanks

Joined: 20 Mar 2007 Posts: 2472 Location: Ontario, Canada

Yes, a T3BP is the one you need.

Just a heads up on the pre-notched saddles though... they are only slightly pre-notched and will need to be filed a touch deeper/wider in order for the strings to seat properly. Easy job though, so no need to worry.

Posted: Sat Nov 17, 2012 10:04 pm

Thanks for the confirmation... Wink

Posted: Sun Nov 18, 2012 1:10 am

clmazza7 wrote:

... for a USA Dean TCZ? I'm so pissed!!! The bridge is actually cracked at the post... WTF?!

There are so many replacement pasrts and I want a direct replacement. Looks like it may be an T3BP ... but not sure.

Thanks

I would thnk that would be covered under some sort of warranty eh Chuck? Something like that happening on a USA is inexcusable, sounds like crap pot metal

Posted: Sun Nov 18, 2012 12:37 pm

Northwinds wrote:

clmazza7 wrote:

... for a USA Dean TCZ? I'm so pissed!!! The bridge is actually cracked at the post... WTF?!

There are so many replacement pasrts and I want a direct replacement. Looks like it may be an T3BP ... but not sure.

Thanks

I would thnk that would be covered under some sort of warranty eh Chuck? Something like that happening on a USA is inexcusable, sounds like crap pot metal

You would think.... Cool

I'm just shocked at how it cracked all the way through. I've never seen anything like it. Like you said... cheap pot metal or a manufacturing defect.

This happens to be on a very early TC... going to check the markings on the bottom when I swap it out.